![]() See the documentation that ships with the server.Ī. O If the amber LED is off, then proceed with the next step.ģ. Wait for data transfer to complete (about 60 seconds), and then proceed with the next step. O If the green LED is off and the amber LED is on, the controller is transferring data from DDR memory to flash memory. Observe the FBWC module LEDs (on page 26): ![]() This method flushes all data from the cache module.Ģ. Close all applications, and then power down the server. Smart Array E200 Controller cache module, 64-MB, without battery 412800-001. Smart Array P400 Controller cache module, 512-MB 405835-001. Smart Array P400 Controller cache module, 256-MB 405836-001. But the cachememory has different part numbers, so just replace the battery. Improper grounding can cause electrostatic discharge.ġ. The battery is the same part number for P400 as for E200. Replacing a P812 cache moduleĬAUTION: To prevent damage to electrical components, properly ground the server before beginning any installation, removal, or replacement procedure. Push the clip firmly at both ends (2) until it clicks into place under the controller board.ĩ.
0 Comments
Leave a Reply. |